Full service
- Check the operation of all systems.
- Ampere pull, and overall check of all electrical components.
- Add a bio-film remover for your internal plumbing.
- Remove and chemically clean your filter.
- Add a shock dose to kill any bugs and nasties.
- Check the cabinet and shell for leaks, damage and condition.
- Check the condition of your cover and clips.
- Drain down your tub.
- Clean the acrylic surface.
- Remove any marks and stains where possible.
- Remove and clean the jets as much as possible.
- Ensure jets operate correctly.
- Rinse out your tub.
- Wet vac out any remaining debris and water.
- Towel dry the surface.
- Remove scale and debris from pumps.
- Check heater element and seals.
- Check pump union seals.
- Re-fill your tub.
- Bleed all pumps of air.
- Re-commission and check for leaks and correct operation.
- Balance the water using the customer’s choice chemicals.
- Check all systems ensuring they work correctly.
- Clean and treat the cover with vinyl protector.
- Re-check ampere pull of components.
- Reset filter cycles and time on control panel.
- Report any problems or advisories to the customer.
Healthy refresh
- Remove your filter and place in our cleaning solution.
- Add a bio-film remover for your internal plumbing.
- Shock dose to kill any bugs and nasties.
- Drain down your Hot tub and clean the acrylic shell.
- Rinse out the tub.
- Wet vac out any remaining debris and water.
- Re fill your tub.
- Re commission and check operation.
- Balance the water using the customers chemicals.
Winter drain down
- Remove and inspect your filter.
- Add a bio-film remover and shock dose for your internal plumbing.
- Soak your filter in our cleaning solution and clean.
- Check the operation of all systems and jets.
- Drain down your tub.
- Rinse out the tub.
- Vac out any remaining water and debris.
- Towel dry the acrylic surface.
- Rinse & dry store your filter.
- Drain water from all components inc heater.
- Loosen any screw fit joints.
- Clean and treat cover and replace.
- Plastic wrap lid if required.
- Isolate power supply so your spa can hibernate for the winter.
Spring start up
- Refit your filter or supply new at an extra cost.
- Rinse tub with fresh water.
- Re-connect all pipe work and heater element if applicable.
- Wet vac any water or debris.
- Re-fill your tub.
- Re-commission and check for leaks and correct operation.
- Balance the water using the customers chemicals.
- Check all systems ensuring they work correctly.
- Clean and treat the cover with vinyl protector.
- Reports any problems or advisories to the customer.
- Replace the cover.